VisualizationPaper Cup Dispenser SVG, Wall Mounted Disposable Cup Holder DXF, Coffee Station Cup Rack, Plywood Cup Tower
A square wall-mounted dispenser for a stack of disposable paper cups: three side walls with long viewing slots, a back wall with two keyhole hangers, two square plates with large round openings and a square gripper ring with radial slits that holds the bottom cup. The free SVG and DXF contain cut lines only, 295.5 × 288.9 mm (11.63 × 11.37 in), with finger joints drawn for 3.8 mm plywood and the gripper meant for 3 mm foam rubber.
- Formats
- SVG, DXF
- Size
- 296 × 289 mm (11.63 × 11.37 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 6.34 m
- Est. time, 10 W diode (3 mm)
- 21 min 09 s
- Est. time, 40 W CO2 (3 mm)
- 8 min 49 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Delete the text note, check your plywood and cup sizes, and test-cut one finger joint and a plate tab.
- 02Cut the four walls and two round-hole plates in plywood and the slit ring in foam.
- 03Join the walls into a tube, slot one plate in, lay the foam ring on it and slot the second plate in.
- 04Hang the box on two screws through the keyholes and load cups from the top, rims down.
How it works
The four walls lock together with finger joints along their long edges into a square tube. Rows of small rectangular slots near the bottom of each wall take the tabs of the two square plates, which hold the stack centred. The plain square with the slit ring sits between them; cut from soft foam, its flexible teeth grip the rim of the bottom cup, so you pull one cup down and the rest stay put. Fill it from the top. The long slots in the front and side walls show how many cups are left, and the two keyhole slots in the back wall hang the box on screws.
Material and settings
The layout includes a short text note: the box parts are drawn for 3.8 mm plywood and the gripper ring for 3.0 mm foam rubber, with suggested speeds. Delete the note before cutting or move it to an engrave layer. If your plywood is a different thickness, measure the slots and scale with a test cut first. Craft foam, EVA foam or thin neoprene all work for the gripper; check the material is safe to laser before you cut it.
Where to use it
A coffee corner in an office, a water cooler, a garage bar, a camper or a market stall serving tea. Check that your cups' rim diameter suits the round openings before cutting, and scale the openings if you use larger cups. Engrave a café name or a "Grab a cup" line on the front wall for a personal touch.
Questions about this file
Which plywood thickness do the joints need?
The note in the file says 3.8 mm plywood for the box and 3.0 mm foam rubber for the gripper ring.
What holds the cups in?
The foam ring with radial slits grips the rim of the bottom cup until you pull it out.
Will my cups fit?
Compare your cup rim with the round openings at full size, and scale the openings if needed.
How is it mounted?
Two keyhole slots in the back wall hang it on screws, so it lifts off for refilling or cleaning.
Can I use felt instead of foam?
Stiff felt works, but soft foam springs back better and grips the rim more evenly.
Similar files



