The formula
A fair price for a laser cut part is the sum of three costs plus your margin:
- Parts per sheet = how many parts fit on the sheet in a grid (the calculator tries both orientations and adds the gap between parts).
- Material per piece = sheet price ÷ parts per sheet.
- Machine per piece = (hour rate ÷ 60) × cutting minutes.
- Cost per piece = material + machine + extras.
- Selling price = cost × (1 + margin ÷ 100).
A worked example
A 24 × 12 in sheet of 3 mm birch plywood costs $9.00. A 4 × 4 in coaster with a 0.1 in gap takes 4.1 × 4.1 in, so 5 × 2 = 10 coasters fit per sheet and the material costs $0.90 each.
With a machine rate of $30 per hour and 3 minutes of cutting and engraving, the laser costs $1.50 per coaster. Add $0.40 for a bag and a sticker: the cost is $2.80. With a 120% margin the selling price is $6.16.
How to find your machine hour rate
Add up what the laser costs you in a month: the machine payment or depreciation, electricity, tube or diode wear, lenses, air assist and extraction, rent for the space and the hours you pay yourself. Divide by the hours the laser actually cuts. If that is $1,200 a month and the laser runs 60 hours, the minimum rate is $20 an hour.
The cutting time of each job is shown by LightBurn or xTool Creative Space before you start. On every file page of DXF World you also find the measured times for a 10 W diode, a 40 W CO2 and a 100 W CO2.
Do not forget the waste
The sheet count assumes a perfect grid. Real nesting loses material at the edges, on test cuts and on failed parts. Raise the gap a little, or add 10–20% to the material cost. For small orders, charge the whole sheet: the offcut is often too small to sell. Read more about pricing laser cut products and nesting to save plywood.