DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Tall white cardboard box folded in stacked sections with half-round vent openings, standing on a wooden table in a kids' roomVisualization
DW-300103 · UPDATED 11/21/2026

Cardboard Box Dieline SVG, Vented Folding Box Template DXF, Laser Cut Packaging Blank, Tall Gift Box Pattern

A one-piece flat blank for a tall folding cardboard box, with solid cut lines, dashed fold lines, tapered shoulder flaps, a wider middle section and half-round tabs that fold open as vents or finger holes. Its free SVG and DXF files show the blank on a 619 × 1654 mm (24.37 × 65.12 in) sheet; it is drawn as separate line segments rather than closed shapes.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
619 × 1,654 mm (24.37 × 65.12 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
9.79 m
Est. time, 10 W diode (3 mm)
32 min 39 s
Est. time, 40 W CO2 (3 mm)
13 min 36 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Split the drawing into a cut layer for solid lines and a fold layer for the dashed lines.
  2. 02Scale the blank to the box size you need and test the folds on a scrap strip.
  3. 03Cut the outline and vent tabs, then perforate or crease the fold lines.
  4. 04Fold the panels, tuck the shoulder flaps and the bottom tab, and push the vents open.

The blank

From top to bottom the blank has a rectangular top section with side flaps, angled shoulder flaps, a wide middle section with three half-round notches along each side of its centre strip and two half-round tabs between them, more angled flaps, a long lower section with seven half-round vent tabs, and a tapered tuck tab at the very bottom. Dashed lines mark every fold. Folded up, it becomes a tall stacked box like the white one in the photo, with the vent tabs pushed open.

Cutting and folding

The dashed fold lines are drawn as real dashes, so a laser or plotter cuts them as a perforation, which folds well in single-wall corrugated board. If you prefer a crease, move the dashes to a separate layer and run them at low power or with a creasing tool on a plotter. Because the outline is made of separate segments, put all solid lines on one layer and the dashes on another before you start. At full size the blank is over 1.6 m long, so most hobby lasers need it scaled down; scaling is fine for a box since nothing has to match a sheet thickness.

Uses

Scaled down, it works as a party favour or gift box; at full size as a ventilated box for plants, bakery goods or small produce. Packaging designers can use it as a starting point and adjust the panel heights to their product.

Questions about this file

What material is it made for?

Single-wall corrugated board or heavy cardstock. Thin plywood will not fold.

Why are the shapes not closed?

The drawing is made of separate line segments. Lasers cut them fine; join them only if your software needs closed shapes.

Can I scale it down?

Yes. A folding box has no slots tied to material thickness, so any scale works as long as the board folds cleanly.

How do I stop the fold lines from cutting through?

Run the dashed layer at low power, or replace the dashes with a single crease line on a plotter.

Can I print a logo on it?

Yes. Add your own artwork as an engraving or print layer before cutting; the file has cut lines only.

Similar files