DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0

DPI converter for print and laser engraving

Check how large an image can be printed or engraved, how many pixels a design needs, and which line interval matches your engraving DPI.

Units

Calculated in your browser. Nothing you type is sent to our server.

Print or engrave size from pixels

How large can this image be?

DPI
Size at 300 DPI10 × 6.67 inExcellent quality

At this DPI the image covers

  • Business card3.35 × 2.17 infits
  • A55.83 × 8.27 infits
  • A48.27 × 11.69 intoo small
  • A311.69 × 16.54 intoo small
  • Coaster 10 cm3.94 × 3.94 infits

Pixels needed for a size

Set up a design for its final size

DPI
pixels2,550 × 3,300

Laser engraving: DPI and line interval

LightBurn uses line interval, other software DPI or LPI

Lines per inch: 254 · Wood and plywood usually engrave well at 250–350 DPI, slate and anodised aluminium at 300–500 DPI. A diode laser's spot is about 0.08–0.1 mm, so very high DPI only adds time.

The formulas

  • Print size = pixels ÷ DPI, in inches. Multiply by 2.54 for centimetres.
  • Pixels needed = size in inches × DPI (or centimetres ÷ 2.54 × DPI).
  • Line interval = 25.4 ÷ DPI, in millimetres. 254 DPI is exactly 0.1 mm.

Example: a 3000 × 2000 px photo at 300 DPI prints at 10 × 6.67 in (25.4 × 16.93 cm). An A4 page at 300 DPI needs 2480 × 3508 px.

Why 300 DPI for print

At normal reading distance the eye cannot see separate dots at 300 DPI, so it is the standard for photos and flyers. Posters and banners seen from a few metres away look fine at 100–150 DPI. A 72 DPI web image printed large looks soft and blocky.

DPI for laser engraving

A laser engraves line by line. The distance between lines is the line interval, and it is the same thing as DPI: 0.1 mm = 254 DPI, 0.08 mm = 318 DPI, 0.05 mm = 508 DPI. Higher DPI is not always better: when the lines overlap more than the laser spot, wood burns darker and the job takes longer. Read what DPI to use for laser engraving and how to turn an image into a laser file.

Questions and answers

How do I convert pixels to centimetres?

Divide the pixels by the DPI to get inches, then multiply by 2.54. 1200 px at 300 DPI is 4 in, which is 10.16 cm.

What DPI should I use for laser engraving photos?

Around 250–350 DPI on wood with a dithering mode such as Jarvis or Stucki. On slate and anodised aluminium 300–500 DPI gives finer detail.

What is line interval in LightBurn?

The distance between two engraved lines in millimetres. It equals 25.4 divided by the DPI, so 0.1 mm is 254 DPI.

Does changing DPI in Photoshop make an image sharper?

No. Changing only the DPI number changes the print size, not the detail. Real detail comes from the pixel count of the original image.

Is 72 DPI enough for printing?

Only for very large prints seen from far away. For anything held in the hand, aim for 300 DPI at the final size.

More free tools