VisualizationCardboard Box Template DXF, Wrap Around Carton SVG, Shipping Box Die Line, Corrugated Packaging Cut File
A one-piece wrap-around carton blank for corrugated cardboard: a single 965 × 1654 mm (37.99 × 65.12 in) sheet with six dashed fold lines and four T-shaped lock slots near the ends. Download it free as an SVG plus a DXF, sized in mm and holding nothing but cut lines. The dashes cut right through as perforations, so the board folds cleanly without scoring.
- Formats
- SVG, DXF
- Size
- 965 × 1,654 mm (37.99 × 65.12 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 10.20 m
- Est. time, 10 W diode (3 mm)
- 33 min 59 s
- Est. time, 40 W CO2 (3 mm)
- 14 min 10 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Measure your item against the middle panel and scale the blank evenly if it needs to be smaller.
- 02Cut a trial copy from thin card and fold it around the item to check the fit.
- 03Cut the blank from corrugated board with air assist on, staying with the machine.
- 04Fold along every dashed line, wrap the panels round the item and push the end flaps into the T-shaped slots.
How the blank folds
The sheet is one long piece divided by six dashed lines into seven panels. The large middle panel is the base. On each side of it come a wide panel and a narrower one, and the two short end flaps have angled corners so they slide in without catching. Near each end a pair of T-shaped slots sits on the last fold line, with a straight slit running down from each slot. When the panels wrap around a flat item, the end flaps tuck over and the slots lock them, so light loads need no tape.
Cutting cardboard safely
Corrugated board cuts quickly on a CO2 laser at low power and high speed. Run air assist, stay with the machine for the whole job and keep a spray bottle close, since paper can flare up. The dashed lines are perforations, not engraving, so they go straight through in short bursts. If a fold line splits apart when you bend it, the dashes are cutting too wide; lower the power a little. Large flatbed cutting tables handle the full size without splitting the job.
Scaling to your product
At 965 mm wide the blank is meant for a large, flat item such as a framed print, a panel or a cut-out sign. Scale it evenly in both directions for something smaller and the panel proportions stay the same. Measure your item against the middle panel first, and fold a test copy from thin card before you cut the good board. Print or stamp your own artwork on the board before cutting, and keep it clear of the fold lines.
Questions about this file
What material is this blank for?
Single-wall or double-wall corrugated cardboard. Plywood and acrylic will not fold along the dashed lines.
Are the dashed lines engraved?
No. They are short cut segments that go right through, so the board bends along them like a perforated line.
Is the full-size blank too big for a hobby laser?
Yes, at 965 × 1654 mm it needs a large machine or cutting table. Scale it down for a smaller carton.
Can I print on the carton?
Yes, print or stamp your design on the flat board first, then cut. Keep artwork away from the fold lines so it does not crack.
Does it need tape?
The T-shaped lock slots hold the end flaps for light items. Add a strip of packing tape when you post it.
Similar files



