DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Five birch plywood divider panels with half-depth slots standing in a row on a wooden tableVisualization
DW-300076 · UPDATED 11/21/2026

Crate Divider Insert DXF, Slotted Box Partition Laser Cut File, 12 Cell Grid Divider SVG, Jar Storage Insert

An egg-crate style partition for a large box or crate: two long panels with three slots each and three shorter panels with two slots each cross-lock into a grid of 12 cells of roughly 15 cm. All five panels come free in one SVG and one DXF, cut lines only, on a 1654 × 638 mm (65.12 × 25.12 in) layout; the panels are about 321 mm tall and the slots run halfway into each panel.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
1,654 × 638 mm (65.12 × 25.12 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
12.43 m
Est. time, 10 W diode (3 mm)
41 min 27 s
Est. time, 40 W CO2 (3 mm)
17 min 16 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Measure your sheet and adjust the slot widths in the file to match it with a little clearance.
  2. 02Cut the two long and three short panels on a CNC router or a large-format laser.
  3. 03Turn the long panels slot side up and the short panels slot side down.
  4. 04Push each short panel into its matching slots until the edges sit flush, then drop the grid into the box.

How the grid works

The two long panels measure about 638 mm and the three short ones about 477 mm, all roughly 321 mm tall. Each slot runs from one edge to the middle of the panel, so a long panel and a short panel slide into each other from opposite sides and finish flush. With two long and three short panels you get three rows of four cells, each about 16 cm on centre. The photo shows the five plates cut from birch plywood and stood side by side before assembly.

Material and slot width

The slots in the file are about 11 to 13 mm wide and not perfectly even, which points to 12 mm plywood cut on a router table or CNC. For thinner sheet, redraw the slots to your material instead of scaling, because scaling would also change the panel size. Rigid corrugated board or 10 mm foam board can be cut on a laser for a light shipping insert. Panels this tall need a large bed, so most laser users will cut them on a router or split them.

Uses

Set it into a wooden crate or a moving box to keep large jars, vases, plant pots, wine glasses wrapped in paper, yarn balls or shoes apart. In a garage it sorts spray cans and paint tins. Makers who sell crates can offer it as an add-on, sized to their standard box.

Questions about this file

What size box does it fit?

An inside size of about 64 × 48 cm and at least 32 cm tall. Trim the panel lengths for a different box.

What thickness are the slots for?

They measure about 11 to 13 mm, so 12 mm plywood is the closest match. Measure them in your software before cutting.

Can I make it shallower?

Yes. Cut the same height off every panel on the side without slots, and shorten the slots so they still reach the middle.

Can I cut it from cardboard?

Yes, with thick corrugated board on a laser. Narrow the slots to the board thickness first.

Can I get more cells?

Add more panels and slots at the same spacing. Each extra long panel adds a row of four cells.

Similar files