VisualizationHitch Ball Wrench DXF, Plasma Cut Trailer Tool File, 12 Point Box End Wrench SVG, Shop Tool
A flat, one-piece box-end wrench for the big nut under a trailer hitch ball: a 12-point ring opening at one end and a tapered handle with five round holes. The free download is one SVG and one DXF file at 507.3 × 76.1 mm (19.97 × 3 in), cut lines only, intended for steel plate on a plasma table or fiber laser.
- Formats
- SVG, DXF
- Size
- 507 × 76 mm (19.97 × 3.00 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 1.43 m
- Est. time, 10 W diode (3 mm)
- 4 min 47 s
- Est. time, 40 W CO2 (3 mm)
- 1 min 59 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Measure the hitch nut across its corners and scale the file so the ring opening matches.
- 02Cut the handle holes first, then the 12-point opening, then the outer profile from steel plate.
- 03Grind off dross and file the inside points until the ring slides onto the nut.
- 04Deburr the edges and paint, powder coat or oil the wrench.
What it is
Hitch ball nuts are larger than most wrenches in a home toolbox, and this profile solves that with a single flat bar. The ring end has a 12-point opening that measures about 55 mm across its outer points, which matches the corners of a 1-7/8 in hex nut. The handle is about half a metre long for leverage and tapers toward the end. Four 12.7 mm holes run along it and a 9.5 mm hole sits at the tip, handy for hanging it on a pegboard hook or a nail in the trailer box. Measure your own nut across the corners before cutting, and scale the file if it differs.
Material and cutting
This is a working tool, so cut it from steel plate, 6–10 mm thick, on a plasma table or a fiber laser. Plywood or acrylic versions will not hold the torque of a hitch nut; use them only as a template to test the fit. Plasma leaves a bevel and dross on the 12-point opening, so clean the inside with a file or a flap disc until it slides over the nut squarely. If your torch kerf is wide, offset the inner contour slightly outward so the opening is not undersized.
Finishing
Knock off sharp edges along the handle, then paint, powder coat or oil it against rust. Stamping the nut size near the ring helps if you make several sizes.
Questions about this file
What nut size does the ring fit?
The opening is about 55 mm across its outer points, which fits a 1-7/8 in hex nut. Always check your own nut first.
Can I cut it on a hobby diode or CO2 laser?
Only as a wooden fit template. A real wrench needs steel plate cut on a plasma table or fiber laser.
What plate thickness is strong enough?
6 mm steel is a sensible minimum for a hitch nut; 8–10 mm gives a stiffer handle.
What are the holes in the handle for?
They save weight and give you a place to hang the wrench; the small hole at the tip suits a hook or lanyard.
Can I make it for a different nut?
Yes, scale the whole file until the ring matches the nut corners, or edit only the ring end in your CAD software.
Similar files



