VisualizationKokopelli SVG, Southwest Pottery Wall Art DXF, Pueblo Pot Silhouette Cut File, Desert Decor Plasma File
A round Southwest-style pottery jug drawn as a silhouette, with a stepped meander band around the shoulder and an open window showing five dancing Kokopelli flute players and a small cactus. The free files, one SVG and one DXF with cut lines only, are drawn at 3297.3 × 2345.6 mm (129.81 × 92.35 in), and the design cuts as a single piece. Scale it down to suit your wall, plasma table or laser bed.
- Formats
- SVG, DXF
- Size
- 3,297 × 2,346 mm (129.81 × 92.35 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 79.10 m
- Est. time, 10 W diode (3 mm)
- 263 min 40 s
- Est. time, 40 W CO2 (3 mm)
- 109 min 52 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Scale the jug to your wall or machine and check the thinnest flute and feather lines.
- 02Cut the shoulder pattern and the figure details first, then the window edge and the outer outline.
- 03Clean off dross or sand the edges, and make sure every figure is still firmly joined.
- 04Paint or seal it, then hang it on standoffs or set it in a slotted base to stand.
What the design shows
The jug has a short neck with an oval rim cut-out, a wide body and a band of hooked, stepped lines around the shoulder in the style of desert pottery. The lower half opens into a window with a ragged rock edge, and inside it five Kokopelli figures dance and play flutes on a ground strip, with a small cactus in the middle. The figures stand on that strip and touch the frame, so the whole jug comes off the sheet in one piece.
Scaling and material
The file is drawn very large, over three metres wide, so you will almost always scale it down. At 600–900 mm it suits a wall in plywood or MDF on a large laser or CNC router, and it is a classic shape for sheet steel on a plasma table. Watch the feather headdresses, fingers and flutes: these thin bridges get weak when you take the design down a lot. The photo shows it in black-finished metal standing on a sideboard.
Finishing and paint
Black satin paint or a rust patina suits the desert theme. For a warmer look, stain plywood a terracotta colour and leave the edges natural. Space the panel 10–15 mm off the wall with standoffs so the figures throw a soft shadow, or cut a slotted base board to stand it on a shelf.
Questions about this file
How big is the file?
3297.3 × 2345.6 mm as drawn. Scale it to the size you need before cutting.
Is it one piece?
Yes. The five figures stand on a ground strip joined to the jug, so nothing falls out.
Can I cut it on a hobby laser?
Yes, scaled down to fit your bed, but keep it large enough that the flutes and feathers stay sturdy.
Is it suitable for plasma?
Yes, at larger sizes. The bold rim and open window handle the wider plasma cut well.
How do I make it stand like in the photo?
Cut a base board with a slot the width of your sheet, or add two small feet along the bottom edge.
Similar files



