DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Large plywood line art tree with a wide fringed canopy and branching trunk mounted on a light wall beside a windowVisualization
DW-300088 · UPDATED 11/21/2026

Spreading Tree Stencil SVG, Line Art Tree Wall Decal DXF, Wide Canopy Tree Cut File, Nature Wall Art Laser Pattern

A broad, umbrella-shaped tree with several overlapping canopy layers, each edged with fine fringe-like strokes, and a short trunk splitting into branches with bark marks. Download it free in SVG and DXF: 81 closed shapes at 188 × 144.8 mm (7.40 × 5.70 in). The fringe strokes and trunk lines cut away as slim slivers, so it works best as a stencil, a vinyl decal or a large wall piece.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
188 × 145 mm (7.40 × 5.70 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
8.82 m
Est. time, 10 W diode (3 mm)
29 min 24 s
Est. time, 40 W CO2 (3 mm)
12 min 15 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Choose the use first: keep it small for vinyl or stencil film, or scale it to 60 cm or more for plywood.
  2. 02Cut a test corner of the canopy to check that the fringe strokes and bridges hold at your size.
  3. 03Cut the inner strokes and bark marks before the outline, then weed or clear the slivers.
  4. 04Apply the decal, paint through the stencil, or finish the wood and mount it on spacers.

What the file looks like

The canopy is a solid mass built from rounded clumps, with groups of thin pointed strokes along the bottom edge of each clump, like hanging needles or grass. Curved lines inside the crown separate the layers. The trunk is drawn as an outline with its branches, and small oval bark marks sit inside it. Every stroke is a closed shape, so the cutter removes it as a sliver and leaves a fringed edge.

Best uses and scaling

At the drawn size the fringe strokes are very fine, which suits a vinyl cutter for wall decals, car decals or paint stencils on fabric and wood. For laser-cut wall art in plywood, scale it up to 60 cm or more so the strokes get wide enough to survive, as with the large wall piece in the photo. Thin bridges between neighbouring strokes break easily when the tree is used small, and loose bark marks inside the trunk fall out unless you keep them as engraving.

Finishing ideas

As a stencil, dab paint through it with a sponge onto a canvas, a tote bag or a wall. As wall art, oil or stain the plywood and mount it on small spacers so the fringe throws a soft shadow. It pairs well with a family name or a quote cut underneath for a living room or a reading corner.

Questions about this file

Is it better as a stencil or wall art?

At its drawn size it is best for vinyl or stencil film. For wood wall art, scale it well up so the fringe stays strong.

What tree is it?

A wide, spreading tree with a layered crown, similar to an acacia or a windswept bonsai.

Why does the canopy edge look hairy?

Each fringe stroke is a thin closed shape that cuts away, giving the soft needle-like edge.

Can I engrave it instead?

Yes, fill the shapes as an engraving on a board, a cutting board or a slate coaster.

Can a diode laser cut it?

Yes, in 3 mm plywood when scaled up, but the many strokes take time, so run a test patch first.

Similar files