VisualizationLattice Coffee Table DXF, Nesting Side Tables CNC File, Moroccan Pattern Furniture SVG, Fretwork Living Room Table Set
A living room set of one low square coffee table and four small side tables, all decorated with a pierced pattern of overlapping arcs and petals. The free SVG and DXF place the parts on two router sheets covering 3178.9 × 2077.2 mm (125.15 × 81.78 in) in total. One sheet holds the 3 large coffee table panels, the other the 12 smaller panels for the side tables.
- Formats
- SVG, DXF
- Size
- 3,179 × 2,077 mm (125.15 × 81.78 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 142.33 m
- Est. time, 10 W diode (3 mm)
- 474 min 26 s
- Est. time, 40 W CO2 (3 mm)
- 197 min 41 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Set up the two sheet layouts in your CAM software and check panel edge steps against your board thickness.
- 02Cut all lattice openings first, then the panel outlines, using a small bit for the arc tips.
- 03Sand the openings, then stain, veneer or paint each panel before joining.
- 04Join the tops and sides with screws, dowels or pocket joints and add a contrasting back board if you like.
What the layout holds
The first sheet has three long panels for the coffee table, each with a lattice band at both ends and a plain middle. The second sheet carries twelve smaller panels, some square, some with a step or tab on one edge, for the four side tables. In the photo, each side table is a top and two lattice sides joined into a U shape, and the large table repeats the same lattice at its corners and on its front. The outer rectangles around each group mark the sheet edges; delete them before cutting if your sheet is already that size.
Cutting and assembly
The file gives no material thickness, so check the step and tab sizes on the panel edges against your board before cutting; 18 mm MDF or plywood is typical for furniture of this size. Cut the lattice holes first so each panel stays held down, then the outlines. The corners in the photo show screwed butt joints, and pocket screws or dowels with glue work well too. Small triangles at the lattice edges are the most delicate parts and need a fine bit.
Finish
A dark walnut veneer or stain with a white board behind the lattice, as shown, makes the pattern pop. Painting the inside faces a contrasting colour gives a similar effect on plain MDF. The side tables slide partly under the big table or line up beside a sofa.
Questions about this file
How many tables are in the set?
One large coffee table from three panels and four small side tables from the twelve smaller panels.
What board thickness should I use?
The file does not say. Measure the steps on the panel edges and pick matching board, often 18 mm for furniture.
Can I make only the side tables?
Yes, cut just the second sheet. Each side table uses a top and two sides.
Can a laser cut this?
The full set is router work. A laser can cut the lattice panels scaled down as dollhouse furniture or trays.
How do I make the pattern stand out?
Put a white or light panel behind the lattice, or paint the inside a contrasting colour.
Similar files



