VisualizationKokopelli Switch Plate Cover SVG, Southwest Light Switch Plate DXF, Flute Player Toggle Cover Laser Cut File
A single toggle light switch cover with a dancing Kokopelli flute player joined to its left edge, his head feathers and raised knee reaching past the plate. It is a free SVG and DXF with cut lines only, 118.8 × 136.9 mm (4.68 × 5.39 in), cut as one piece with a rectangular toggle opening and two screw holes.
- Formats
- SVG, DXF
- Size
- 119 × 137 mm (4.68 × 5.39 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 1.06 m
- Est. time, 10 W diode (3 mm)
- 3 min 32 s
- Est. time, 40 W CO2 (3 mm)
- 1 min 28 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Print or overlay the file at full size and check the toggle slot and screw holes against your switch.
- 02Cut the cover from 3 mm plywood or acrylic, keeping the flute and foot bridges intact.
- 03Sand the edges lightly and paint or stain the cover, then add a clear coat.
- 04Turn off the power, remove the old cover and screw the Kokopelli cover on with the original screws.
How the cover works
The right part of the file is a plain rectangle with a toggle slot in the middle and a screw hole above and below it. Kokopelli is fused to the left side of the plate: three curved head feathers, a bent back, the flute held to his face and one leg kicked up while the other stands on the bottom edge. The figure overlaps the wall, so it reads like he is dancing out from behind the switch.
Check the fit before cutting
A switch cover has to match the hardware, so do not resize it like wall art. Lay your current cover over a printout at 100 % and compare the toggle opening and the two screw holes. If your switch is a different standard, move the holes and slot in your software and leave Kokopelli as he is. The flute and the raised foot have the thinnest bridges, so cut from 3 mm plywood or acrylic with a clean, sharp focus.
Finishing and paint
The photo shows the cover in matte black, which suits a Southwest or desert-style room. Turquoise, terracotta or rust paint look just as good. Seal it with a clear coat so fingers do not mark the paint around the toggle. Mount it with the short screws from your old cover, as longer screws can crack thin plywood. Sets for a whole house, or a pair with a double switch version, make a nice housewarming gift for fans of New Mexico or Arizona decor.
Questions about this file
Will it fit a standard toggle switch?
It has one toggle opening and two screw holes. Compare them with your switch at full size before cutting, and move them if your hardware differs.
Can I scale it up?
Only the Kokopelli figure can grow; the plate part has to stay the size of your switch, so edit them separately.
What material is safest?
3 mm plywood or acrylic is common. Avoid metal unless you know how to keep a metal plate safely away from live parts.
How do I stop the paint wearing off?
Finish with two thin coats of clear lacquer, as hands touch the area around the toggle every day.
Can I make him face the other way?
Mirror the file and the figure ends up on the right side of the switch.
Similar files



