DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Four light plywood plaques with cut-out flowers and leaves, three small ones in a row above a long flower border, on a cream wallVisualization
DW-300063 · UPDATED 11/21/2026

Botanical Wall Panel Set SVG, Flower Silhouette Plaques DXF, Gallery Wall Plant Art Laser Cut File, Folk Flower Border

A set of four rectangular plaques with plant silhouettes cut out of them: a drooping bell-shaped flower with its bud, a stem of round-petalled blossoms, a leafy sprig with a curl, and a long panel with a central flower and leaf branches spreading to both sides. The free SVG and DXF contain cut lines only and lay all four out in 456.7 × 398.2 mm (17.98 × 15.68 in).

Author
DXF World · 530 files
Formats
SVG, DXF
Size
457 × 398 mm (17.98 × 15.68 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
10.58 m
Est. time, 10 W diode (3 mm)
35 min 16 s
Est. time, 40 W CO2 (3 mm)
14 min 42 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Place the four plaques on your sheets, moving the long border panel to its own sheet if needed.
  2. 02Cut the plant openings first and the rectangular outlines last.
  3. 03Sand the inside edges of the openings and finish the faces with oil, wax or paint.
  4. 04Hang the three upright plaques in a row with the wide border panel centred underneath.

The four panels

The three upright plaques are close in height and work as a row. The first holds a bell flower hanging from an arching stem with a tall bud beside it, the second a curving stem with two rounded blossoms, the third a branching sprig of soft round leaves ending in a little curl. Below them, the wide panel is a symmetrical folk-style border: one tulip-like flower in the middle and pointed leaves fanning out left and right. Each plant is a negative shape, so the wall colour shows through the opening.

Where to hang them

The photo shows the usual arrangement: three small plaques in a row with the long one centred under them, about 10 mm apart. The same set also suits a hallway, above a bed or over a kitchen bench. Paint the wall behind in sage or terracotta and the plants read in that colour. Or glue a sheet of coloured card or fabric behind each opening for a framed look.

Cutting and material

Plywood or MDF in 4–6 mm gives the plaques enough stiffness to hang flat. Most openings are single closed shapes, so the cuts are quick; only a few small details, such as the crescent in the centre flower of the long panel, drop out as tiny scraps. If your laser bed is smaller than the layout, move the long panel onto its own sheet. The plaques can also go much larger on a CNC router, and the shapes double as wall paint stencils.

Questions about this file

How many pieces are in the set?

Four plaques: three upright ones with single plants and one wide horizontal border.

Can I use them as stencils?

Yes, the plants are cut-through shapes, so a thin plaque works as a paint stencil for walls or furniture.

Which thickness should I use?

4–6 mm plywood or MDF keeps the plaques flat on the wall; 3 mm is fine for small table versions.

Can I put a colour behind the cut-outs?

Glue painted card, fabric or a thin acrylic sheet to the back of each plaque.

Can I cut only one panel?

Of course; each plaque is a separate closed shape, so delete the others before sending the job.

Similar files