DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Large black round wall art with two tulips, a bud, leafy stems and round blossoms inside a ring, hanging on a warm white wallVisualization
DW-300046 · UPDATED 11/21/2026

Round Tulip Wall Art SVG, Floral Circle Wall Hanging DXF, Spring Flower Line Art Laser Cut File, Botanical Hoop Sign

A round line-art flower panel: two wide open tulips with feathery stamens, a closed bud in the middle, branching leafy stems and three clusters of round petals, all held inside a thin outer ring. The free SVG and DXF contain cut lines only and measure 203.2 × 203.2 mm (8.00 × 8.00 in); the design is one connected piece that scales to any wall.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
203 × 203 mm (8.00 × 8.00 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
6.86 m
Est. time, 10 W diode (3 mm)
22 min 52 s
Est. time, 40 W CO2 (3 mm)
9 min 32 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Scale the circle to its final diameter and check that the thinnest outlines stay above 2 mm.
  2. 02Cut all inner openings first, then the outer edge of the ring.
  3. 03Pop out the scrap pieces gently, sand any rough spots and remove smoke marks with a damp cloth.
  4. 04Paint or oil the panel and hang it on one screw at the top of the ring or on wall spacers.

The design

Everything is drawn as an even outline, about the same width all over, so the finished piece looks like a pen drawing hung on the wall. Two big tulips lean outward from the centre, each with a cluster of curled stamens on its outer side. A small closed bud sits between them, and pointed leaves climb the central stems. Three round flowers with scalloped petals fill the top, the lower left and the lower right of the ring. Every line touches its neighbour or the outer ring, so the whole thing comes out as one piece.

Scaling and material

At the drawn 203.2 mm it works as a small plaque or a window hanger in 3 mm plywood. For a statement piece like the black one in the photo, scale it to 500–600 mm and cut it in 6 mm plywood, MDF or steel on a plasma table. Shrinking it below 200 mm makes the outlines very thin, and they break easily, so scale up rather than down. Expect a lot of inner cut-outs; on a diode laser, run the inside shapes first and the ring last so the panel does not shift.

Finishing ideas

Black paint gives the crisp graphic look, while natural birch reads softer in a nursery or a spring kitchen. Hang it on a single screw through the top of the ring, or mount it 10 mm off the wall on spacers so the outlines cast a second drawing in shadow. It suits Mother's Day, a garden-lover's birthday or a set with other round floral panels.

Questions about this file

Is it one piece?

Yes. Every outline connects to the next one or to the outer ring, so nothing falls out except the scrap.

What size works best?

203.2 mm as drawn is the minimum; 400–600 mm gives bolder lines and a stronger wall piece.

Does it work as a steel plasma piece?

Yes, scaled up to around 600 mm it is a good plasma design, as the outlines are even in width.

How do I make the shadow effect?

Mount it on small spacers a few millimetres off the wall and light it from the side.

Can I add a name or date?

Engrave it on a separate small plaque under the ring, as the panel itself has little solid space for text.

Similar files