DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Black metal alpaca in bold formline style standing in front of a crescent moon ring, on a wooden table in a bright living roomVisualization
DW-300038 · UPDATED 11/21/2026

Alpaca SVG, Llama Wall Art Laser Cut File, Formline Style Moon Ring DXF, Metal Llama Sign

A one-piece wall art panel of an alpaca drawn in bold formline shapes, with ovoid and U-shaped openings in its body, standing in front of a large crescent moon ring that carries a carved face. Download it free as SVG and DXF, cut lines only, sized 289.6 × 373.4 mm (11.40 × 14.70 in) and scalable for plywood, acrylic or steel.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
290 × 373 mm (11.40 × 14.70 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
6.91 m
Est. time, 10 W diode (3 mm)
23 min 03 s
Est. time, 40 W CO2 (3 mm)
9 min 36 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Scale the panel to your wall or shelf and check the thinnest part of the ring.
  2. 02Cut the inner openings first and the outer outline last, so the piece stays flat.
  3. 03Clean off soot or plasma dross and sand any rough corners.
  4. 04Paint or lacquer it, then mount it on spacers or let it stand on its feet.

What the panel shows

The alpaca faces left with its long neck upright and ears pricked. Its body, hip and shoulder are filled with the rounded ovoid and U shapes typical of formline art, and its four slim legs end in small flat feet. Behind it, a wide ring curves from the back of the neck down past the tail, with a stylised face, eye and notches cut into it. The animal touches the ring at the neck, tail and feet, so everything stays one piece. In the photo it is cut from black steel and stands upright on its feet on a table.

Scaling and material

At 289.6 × 373.4 mm it suits a shelf or a small wall. The ring has long thin sections at the bottom, so do not shrink it much below this size in wood. For a garden or porch sign, enlarge it to at least 600 mm and use 2 to 3 mm plasma-cut steel or 6 mm exterior plywood. In 3 mm black acrylic it makes a sharp modern piece.

Finishing and display

Paint steel with outdoor black enamel, or leave plywood natural with a matte lacquer. Hang it on short standoffs a finger width from the wall and its shadow repeats the shapes. Llama and alpaca fans buy these for farm stands, yarn shops and boho nurseries.

Questions about this file

Is this an alpaca or a llama?

It works for both; the short ears and neat body read as an alpaca, but most buyers search for llama art too.

Will it stand by itself?

In steel it can stand on its flat feet like in the photo. In plywood, add a small slotted base for stability.

How small can I cut it?

Around the drawn size is the practical minimum in wood. Smaller than that, the thin parts of the ring break easily.

Which material looks best?

Black steel or black acrylic shows the bold formline shapes best. Natural birch gives a softer, warmer look.

Can it hang outdoors?

Yes, in powder-coated steel or sealed exterior plywood. Indoor MDF will swell outside.

Similar files