DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
White acrylic bar with five rounded slots and rounded corners standing upright on a wooden shelf by a windowVisualization
DW-300034 · UPDATED 11/21/2026

Screwdriver Holder DXF, Five Slot Tool Rack Laser Cut File, Wall Mounted Driver Organizer SVG, Cable Holder Bar

A single flat bar with five rounded slots that open to one long edge, for hanging screwdrivers, hex keys or cables by their shafts. It is a free SVG and DXF file, cut lines only, sized 193 × 76.2 mm (7.60 × 3.00 in); each slot is about 6.6 mm wide and 41 mm deep, and the bar has two rounded corners on the open side.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
193 × 76 mm (7.60 × 3.00 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
0.89 m
Est. time, 10 W diode (3 mm)
2 min 59 s
Est. time, 40 W CO2 (3 mm)
1 min 14 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Choose 3 to 6 mm plywood or acrylic, and check your shaft sizes against the 6.6 mm slots.
  2. 02Mark two screw holes in the solid band above the slots, or plan a batten to glue it onto.
  3. 03Cut the bar and sand the inside of each slot so the tools slide in smoothly.
  4. 04Screw it under a shelf or onto brackets with the slots facing out, then hang the drivers.

The design

The bar is a plain rectangle with five evenly spaced slots running in from the bottom edge, each ending in a round top so tools slide in easily. The two outer corners on the slotted side are rounded off, which keeps it from catching on sleeves when it is mounted. It is a single part with no joints, so any sheet thickness works. The photo shows it cut from white acrylic and standing on a windowsill shelf.

How to mount it

Fix the bar flat, slots facing out, under a shelf or on a pair of small brackets on the workbench wall: a screwdriver drops in by its shaft and hangs from its handle. Mounted upright against the edge of a desk, the same slots hold charging cables with the plug resting on top. Use 6 mm plywood or acrylic for tool weight; 3 mm is enough for cables. Drill two screw holes in the solid band above the slots, or glue the bar onto a wooden batten.

Adapting it

The 6.6 mm slot width fits most small and medium screwdriver shafts. For a longer rack, place two bars end to end on one batten and you have ten slots. Hobby shops and makers' markets sell these as quick add-ons to pegboards and tool walls, and with a name engraved on the front they make a small gift for a DIY dad.

Questions about this file

Which tools fit the slots?

Screwdrivers, nut drivers and hex keys with shafts up to about 6.5 mm, and most charging cables.

Can I make the slots wider?

Yes, but do not just scale the file, which makes the whole bar bigger. Edit the slot width in your design software.

Does it come with mounting holes?

No. Add two holes in the solid upper band to suit your screws before cutting.

Which material is strongest?

6 mm birch plywood or 5 to 6 mm acrylic carries a full set of screwdrivers without bending.

Can I use it as a cable organizer on a desk?

Yes. Stand it upright on the desk edge with a small bracket so cables drop into the slots with the plugs on top.

Similar files