DXF / SVG / GeneratorsFiles. Tools. Possibilities.
EN
Saved0
Pair of purple acrylic round earrings with many bubble-shaped holes, hanging from gold hooks on a frosted display standVisualization
DW-300096 · UPDATED 11/21/2026

Acrylic Circle Earring SVG, Bubble Pattern Earrings DXF, Organic Cutout Disc Earrings, Round Dangle Earring File

A pair of round dangle earrings, each disc pierced by dozens of rounded, pebble-like holes in different sizes, small in the middle and larger towards the edge. The free SVG and DXF contain cut lines only for both discs side by side, 40 × 19.2 mm (1.57 × 0.76 in) in total, sized for 2–3 mm acrylic or thin wood.

Author
DXF World · 530 files
Formats
SVG, DXF
Size
40 × 19 mm (1.57 × 0.76 in)
Material
Plywood, MDF, acrylic or metal (scale to your piece)
Cut length
1.47 m
Est. time, 10 W diode (3 mm)
4 min 53 s
Est. time, 40 W CO2 (3 mm)
2 min 02 s
Layers
CUT only, no engraving

Free account required to download

How to make it

  1. 01Choose 2–3 mm cast acrylic or thin plywood and check the bubble walls at your chosen size.
  2. 02Cut the bubble holes first with air assist, then the outer circles, keeping the film on.
  3. 03Peel the film, wipe off dust and check that every bubble dropped out cleanly.
  4. 04Open a jump ring through a small hole near the top edge and add an earring hook.

The design

The holes look like soap bubbles or a slice of coral: smooth, rounded and packed close, with thin walls between them. The two discs are not identical copies, so the pair looks hand made rather than stamped. There is no separate jump ring hole; one of the small bubbles near the top edge takes the ring, as in the photo, where the discs hang from gold hooks. If you prefer a fixed spot, add a 1.5 mm hole just inside the rim in your software.

Cutting tiny parts

Each disc is only 19.2 mm across, and the walls between bubbles are very narrow, so slow down and use air assist. A CO2 laser cuts 2–3 mm cast acrylic cleanly; on a diode laser choose dark or opaque acrylic, since clear and many light colours let the beam pass through. Cut the holes before the outer circle and keep the sheet flat with pins or tape so nothing shifts. Leave the protective film on until the end to avoid smoke marks. Scaling the discs up to 30–40 mm gives thicker walls and a bolder statement earring.

Selling and gift ideas

Purple, as in the photo, cobalt and teal read strongly; mirror gold or a pearl finish suits weddings. Make a matching pendant by scaling one disc to 35 mm. Pairs on printed earring cards sell well at craft markets, and a set in three colours is an easy birthday gift.

Questions about this file

Is there a hole for the earring hook?

Use one of the small bubbles near the top edge, or add a 1.5 mm hole just inside the rim before cutting.

Can a diode laser cut these?

Yes, in dark or opaque acrylic or thin wood. Clear and light acrylic usually do not cut on a diode.

How big are the earrings?

Each disc is 19.2 mm across; both sit side by side in 40 × 19.2 mm.

Can I make them bigger?

Yes, 30–40 mm discs look bold and the walls between bubbles get stronger.

Are the two discs the same?

The bubble patterns differ slightly, which gives the pair a natural look.

Similar files