VisualizationFlower Vine Wall Decor SVG, Vertical Floral Border Laser Cut File, Folk Flower Stencil DXF, Tall Wall Art Pieces
A tall vertical flower border made of four repeating folk-style flower clusters, each built from a fan of petals, a bud, two serrated leaves and curved stem pieces. The free download is one SVG and one DXF file, 391.3 × 1903.2 mm (15.41 × 74.93 in), cut lines only; the 54 shapes are separate pieces that you fix to a wall or backer board, or cut out of one sheet to use as a painting stencil.
- Formats
- SVG, DXF
- Size
- 391 × 1,903 mm (15.41 × 74.93 in)
- Material
- Plywood, MDF, acrylic or metal (scale to your piece)
- Cut length
- 18.64 m
- Est. time, 10 W diode (3 mm)
- 62 min 08 s
- Est. time, 40 W CO2 (3 mm)
- 25 min 54 s
- Layers
- CUT only, no engraving
Free account required to download
How to make it
- 01Split the layout into its four flower clusters and arrange one cluster per sheet for your bed size.
- 02Cut all 54 shapes, keeping each cluster's pieces together and marking the backs with a number.
- 03Paint or finish the pieces while they are flat, then dry-fit the whole vine on the floor.
- 04Mark a plumb line on the wall and fix the pieces from the top down with mounting tape or small pins.
A border made of loose pieces
Unlike a one-piece panel, nothing in this file is joined. Each of the four flower clusters is a set of individual shapes: five to seven long petals fanning out, a lobed bud in the center, two jagged leaves below, a short stem sliver and a forked stem piece that leads down to the next flower. Laid out in a column they read as one climbing vine nearly 1.9 m tall. The photo shows them in black metal fixed straight onto a cream wall beside a window, which is the cleanest way to use it.
Three ways to use the file
- Wall pieces. Cut every shape from 3 mm plywood, MDF or acrylic, paint them, and stick them to the wall with double-sided mounting tape. Lay the cut sheet on the floor first and number the backs so the layout stays right.
- Backer board. Glue the pieces onto a narrow painted board (about 450 mm wide) for a hanging panel that can move house with you.
- Stencil. Cut the whole layout from thin stencil film or card and keep the sheet, not the pieces. Each section of the vine can be painted onto a wall, a door, or a wooden chest.
Fitting it to your laser
At full size the strip is 1.9 m long, longer than most hobby beds. Because the pieces are separate, you can simply cut one flower cluster at a time; each is under 500 mm tall. To make a shorter border, use two or three clusters instead of scaling everything down, which keeps the thin stem pieces strong. For a plasma table, the shapes are large and simple enough for 1–2 mm steel.
Questions about this file
Are the petals and leaves connected?
No. All 54 shapes are separate, so you place them yourself on a wall, a board or a furniture panel.
Can I make a horizontal border instead?
Yes. Rotate each flower cluster and line them up side by side above a door, a bed or a kitchen backsplash.
Does it work as a wall stencil?
Very well. Cut it from stencil film or thin card and paint through the openings; the gaps between petals act as natural bridges.
What finish suits a bathroom or kitchen wall?
Acrylic pieces, or MDF sealed on all sides with primer and paint, so damp air does not swell the edges.
How do I keep the spacing even?
Cut the full layout once on paper or card as a template, tape it to the wall, and place each piece over its outline.
Similar files



